마란츠 인티앰프 PM-99se

by 늘푸른솔 posted Aug 01, 2017
?

단축키

Prev이전 문서

Next다음 문서

ESC닫기

크게 작게 위로 아래로 댓글로 가기 인쇄 첨부
Extra Form
전화번호 --

마란츠 인티앰프 PM-99se입니다.

220V

454 * 170 * 460mm 폭 높이 깊이

출고가 33000엔

 

AB급 동작시

200w+200w 4옴

160w+160w 6옴

130w+130w 8옴

 

A급 동작시

30W+30W 8옴

포노단 MM, MC 전환단자

CD 발란스 단자

무게............26.0k

마란츠에서 92년에 40주년 기념작으로 한정발매된

마란츠 인티 최고봉으로 발매 당시 데단한 센세이션을 일으킨 하이앤드급 제품입니다,

댐핑력 대단하며 순수하고 결이 지극히 고운 고품질 음질을 들으실 수 있습니다.

리시버류의 음색하고는 많은 차이가 있습니다.

6면이 모두 동판으로 되어 있으며 대부분의 볼트는 물론 발통까지도 동으로 되어있습니다.

국내에서는 접해보기도 쉽지 않은 제품입니다.

모든 작동 이상없습니다.

리모콘이 없는 제품이다 보니 파워버튼의 글씨는 지워져 있습니다,

상판에 작은 흠집 두어군데 있으며 자잘한 세월의 흔적있지만

크게 흠잡을 곳 없는 거의 민트급 제품입니다.

실물사진입니다,

착불 ***만원입니다. (종료)

직거래는 온수역인근입니다.

부천에서 출발하는 고속버스 가능합니다.

010-5250-4011

 

marantz-pm-99se.jpg

 

marantz-pm-99se-sa.jpg

 

marantz-pm-99se-op.jpg

 

marantz-pm-99se-l.jpg

 

marantz-pm-99se-w.jpg

 

marantz-pm-99se-b.jpg

 

marantz-pm-99se-bs.jpg

 

marantz-pm-99se-bu.jpg

 

marantz-pm-99se-s-cu.jpg

 

marantz-pm-99se-bt.jpg

 

marantz-pm-99se-up.jpg

 

       ***************

 

Marantz PM-99SE 330,000yen(1992 release)

 

Description
 
The Integrated Amplifier which gave tune amplifier based on the chassis construction of PM-90. 
The unification part of SE series and newly developed technologies including a high-speed module are supplied, and S/N on Hearing impression and the further improvement in speaker drive capacity are aimed at. 

A total of ten HDAM which is the high-speed voltage amplification modules which realize an exact signal amplification in several seconds is adopted. 
Thereby, a feeling of density and speediness of play sound are improved. 

The new model MOS FET was selected carefully to the power block, and it has adopted by the parallel push pull. 
The electric-current drive capacity to exceed the time of a triple push pull using of conventional MOS FET by this is acquired. 

By combining HDAM with 4-unit active volume, the volume part has expanded the gain variable span sharply. Moreover, by adopting a resistor rotation type as volume component partses, and considering it as a low-impedance specification, S/N at the time of a real using is raised. 

The low double foil chemicon with a copper shielding, the top cover of the 70micro foil printed circuit board, a silicon steel board shielding board, a sub- die-casting panel, a copper plating die-casting chassis, and 3mm thickness, etc. are adopted, and shielding capacity and vibration suppression nature are raised. 

The large-sized toroidal power transformer is adopted as a power-source part. 

 
Rear
Power-source Power
HDAM 4-unit

 

Rating of a mode
Form Stereo Integrated Amplifier
Output power
At the time of a Class-A operation : 60W+60W (4ohms) 
40W+40W (6ohms) 
30W+30W (8ohms)
At the time of AB class operation : 200W+200W (4ohms) 
160W+160W (6ohms) 
130W+130W (8ohms)
THD 0.005%
Frequency characteristic 10Hz-100kHz+0 -1 dB
SN ratio High Level:111dB
Input terminal compact-disk balance input: One line 
Line input: Four lines 
Phono input: One line 
DCC, a Tape input: Three lines
Output-terminal DCC, a Tape output: Three lines 
Speaker output: One line
Power consumption 350W (Electrical Appliance and Material Control Law)
Dimensions Width 454x height 170x depth of 460mm
Weight 26.0kg